Friedrich US08 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
6
Operating Instructions
F1 LOW
F2 MED
F3 HIGH
REMOTE CONTROL SIGNAL
RECEIVER
POWER
MODE
-
Push this button to shift mode of operation from COOL
MONEY SAVER FAN.
- COOL :
Fan runs continually for normal cooling operation.
- MONEY SAVER:
The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on
and the unit will check the room air to determine if cooling is needed.
- FAN :
Fan-only operation.
TIMER
- SHUT-OFF TIME
You will usually use shut-off time while you sleep.
If unit is running, use Timer to set number of
hours until shut-off.
For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 min.,
and once again after another 30 min.
Push Timer button to advance setting from
1 Hour
2 Hours
....
12 Hours maximum.
- START TIME
If unit is off, use Timer to set number of hours
before unit starts.
Push Timer button to advance setting from
1 Hour
2 Hours
.....
12 Hours maximum.
TEMPERATURE SETTING
Use this button to automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F to 86°F by increments of 1°F.
The setting appears in the display.
To turn the air conditioner ON, push this
button.
To turn the air conditioner OFF, push the
button again.
This button takes priority over any other
button.
When you first turn it on, the unit is in
cool mode, at High fan speed, and set at
a temperature setting of 72°F.
FAN SPEED
Every time you push this button, it
advances the setting as follows:
{High Low Med High}
Operating Instructions
Controls
AUTO RESTART
When power is restored after an electrical power failure, the unit will begin to run at its previous setting.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Comments to this Manuals

No comments