Friedrich RT2 User Manual download pdf

Before installing thermostat, turn off all power

to unit. There may be more than one power

disconnect. Electrical shock can cause per-

sonal injury or death.

Improper wiring or installation may damage

thermostat. Wiring must conform to local and

national electrical codes.

WARNING

920-162-01 (5-05)

INSTALLATION CONSIDERATIONS

The thermostat is a wall mounted, low-voltage thermostat,

which maintains room temperature by controlling the opera-

tion of a heating and air conditioning system. Batteries are

not required; temperature and mode settings are preserved

with the power off.

I. THERMOSTAT LOCATION

Thermostat should be mounted:

- Approximately 5 ft. (1.5m) from ﬂ oor.

- Close to or in a frequently used room, preferably on an

inside partitioning wall.

- On a section of wall without pipes or duct work.

Thermostat should NOT be mounted:

- Close to a window, on an outside wall, or next to a door

leading to the outside.

- Exposed to direct light and heat from a lamp, sun,

ﬁ replace, or other temperature-radiating object which

may cause a false reading.

- Close to or in direct airﬂ ow from supply registers and

return-air grilles.

- In areas with poor air circulation, (behind a door or in

an alcove.)

II. INSTALL THERMOSTAT

1. Turn off all power to unit.

2. If an existing thermostat is being replaced:

A. Remove existing thermostat from wall.

B. Disconnect wires from existing thermostat, one at

a time. Be careful not to allow wires to fall back into

the wall.

C. As each wire is disconnected, record wire color and

terminal marking.

D. Discard or recycle old thermostat.

NOTE: Mercury is a hazardous waste and MUST be

disposed of properly.

3. Separate the thermostat and back plate.

4. Route thermostat wires through hole in back plate. Level

back plate against wall (for aesthetic value only - thermo-

stat need not be leveled for proper operation) and mark

wall through 2 mounting holes.

4.55

3.30

Selects System Mode:

OFF. HEAT, or COOL

Increase

Temperature

Decrease

Temperature

Turns Continuous Fan

On or OFF

0.8

Installation Instructions

SINGLE STAGE HEAT/COOL THERMOSTAT

Please read these instructions completely before attempting installation.

Model RT2

1 2 3 4

Summary of Contents

Page 1 - Installation Instructions

Before installing thermostat, turn off all power to unit. There may be more than one power disconnect. Electrical shock can cause per-sonal injury or

Page 2 - IV. THERMOSTAT OPERATION

2 5. Drill two 3/16-in. mounting holes in wall where marked. (Note: Mounting holes on back plate are designed to ﬁ t on a horizontal J-box).6. Secu

Page 3 - V. THERMOSTAT CONFIGUR ATION

3V. THERMOSTAT CONFIGUR ATIONThis thermostat has been carefully conﬁ gured at the factory to provide optimum operation for most installations. The se

Page 4

FRIEDRICH AIR CONDITIONING CO. INC.Post Ofﬁ ce Box 1540 · San Antonio, Texas 78295-15404200 N. Pan Am Expressway · San Antonio, Texas 78218-5212(210)

Comments to this Manuals

No comments

Friedrich RT2 User Manual

Browse online or download User Manual for Thermostats Friedrich RT2. Friedrich RT2 User's Manual

Summary of Contents

Comments to this Manuals