Friedrich PDH07K3SG Installation Manual download pdf

VERIFY KIT CONTENTS

Before starting installation, make sure that the following

parts are included:

• One sheet metal wall sleeve adapter.

• Two long and two short pieces of styrofoam insulation

with adhesive backing.

• Two long and two short adhesive-backed gasket pieces.

• Two Tinnerman's Clips.

• Ten #10 screws.

920-127-01 (1-05)

Installation Instructions

WALL SLEEVE ADAPTER KIT

For Use With Packaged Terminal Units

Please read these instructions completely before attempting installation.

NOTE: This kit retroﬁ ts the earlier shallow "T" series Friedrich wall sleeve to accommodate more modern, deeper

"PD" series PTAC units. Refer to Chassis Installation/Operation Manual for additional information.

Model PXSE

WARNING

Electrical shock hazard.

Electrical power MUST be disconnected.

Failure to disconnect power can result in

property damage, personal injury and/or death.

STEP 1: WALL SLEEVE ADAPTER ORIENTATION

The wall sleeve adapter increases the depth of existing wall sleeves to accept deeper PTAC units. The adapter

mounts to the front of the existing sleeve inside of the room. The sleeve should be oriented so that the Stickout

Flange is inside the existing sleeve and the Fold-over Flange is positioned to the bottom front of the adapter

as shown in illustration.

Fold-over

Flange

Room

Existing Wall

Sleeve

Wall

Sleeve

Adapter

Stickout

Flange

STEP 2

Insert the stickout flange of the wall sleeve adapter over the bottom flange of the existing sleeve.

Make sure that the top of the sleeve is level with the top surface of the adapter.

1 2 3 4

Summary of Contents

Page 1 - Installation Instructions

VERIFY KIT CONTENTSBefore starting installation, make sure that the following parts are included:• One sheet metal wall sleeve adapter.• Two long and

Page 2

2STEP 4Install two Tinnerman's clips over the holes on the top flange of the wall sleeve. The flat round hole on the Tinnerman's clips shou

Page 3

3STEP 6Fasten the adapter to the wall sleeve with six ½" long #10 screws. All screws are driven from the inside of the adapter into the Tinnerm

Page 4 - Printed in the U.S.A

920-127-01 (1-05)FRIEDRICH AIR CONDITIONING CO. INC.Post Office Box 1540 · San Antonio, Texas 78295-15404200 N. Pan Am Expressway · San Antonio, Texas

Friedrich PDH07K3SG Installation Manual

Browse online or download Installation Manual for Unknown Friedrich PDH07K3SG. Friedrich PDH07K3SG Friedrich PTAC Sleeve Extension Retrofit Kit Installation Instructions [de] User Manual

Summary of Contents

More documents for Unknown Friedrich PDH07K3SG

Comments to this Manuals

Friedrich PDH07K3SG Installation Manual

Browse online or download Installation Manual for Unknown Friedrich PDH07K3SG. Friedrich PDH07K3SG Friedrich PTAC Sleeve Extension Retrofit Kit Installation Instructions [de] User Manual

Summary of Contents

More documents for Unknown Friedrich PDH07K3SG

Comments to this Manuals

Related products and manuals for Unknown Friedrich PDH07K3SG