Friedrich Heat Pump 920-087-09 User Manual download pdf (Page 19)

FRP020

SHIPPING

TAPE

Figure 20

Shipping Tape Location

FRP021

REMOVE SHIPPING

SCREW IF PRESENT

Figure 21

Shipping Screw Location

Figure 22

Removing Front Panel

CAUTION

Unit Damage Hazard

Failure to follow this caution may result in equipment damage

or improper operation.

Failure to remove shipping tape and screw will prevent fresh

air vent door from opening and may result in damage to vent

door cable.

3. Carefully remove shipping tape from the front panel and vent door.

See Figure 20

4. Remove shipping screw from the vent door, if present. See Fig 21.

5. Remove front panel. See Figure 22.

Pull out at the bottom to release it from the tabs (1). Then lift up (2).

NOTE: If the unit is mounted ush to the oor, the service cord MUST

be rerouted at the bottom of the front cover on the side closest

to the receptacle. A notch MUST be made in the front cover

side where the cord exits the unit. It is the responsibility of

the installer to create an exit notch.

FRP022

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

No comments

Friedrich Heat Pump 920-087-09 User Manual Page 19